antiqueqert.blogg.se - Opensprinkler setup wifi

#Opensprinkler setup wifi install#

You can change it later in the app if you want to. It will list a device number select it.Open the app and choose Scan for Device.Download the OpenSprinkler app for your phone Using your phone: Go to your phone App Store, or Google Playetc.

#Opensprinkler setup wifi install#

RD-Wireless is now connected to your home network Install the phone App and connect

In your phone settings, re-connect to your home WiFi network (The OS_…) network will no longer appear.

Within 30 seconds, LED4 on the timer should turn on indicating that it is connected to the home wifi network.

After it says Connecting… go to the next step note that the web browser may quit responding.

Press Submit to connect the timer to your home WiFi network.

Select your Home WiFi router from the list and enter the passcode.

Open a web browser (Chrome, Safari, etc.) and enter the address/URL: 192.168.4.1.

You’re just temporarily connecting directly to the timer using a non-encrypted (unsecured) connection)

(Note: Continue even if you see a warning about an insecure connection.

(E.g., In the list of available networks, you will see the timer’s WiFi network named something like OS_123ABC but the numbers/letters will be different.).

Connect your smartphone to the local WiFi network starting with OS_.

The top board should be lined up to the side edges of the bottom board.

If not, remove it and slide it left or right, and re-insert it until you see the lights flash. Install and turn on the power the LEDs will flash and the 24VAC LED should be green.You can trim the nub down on the switch with a pair of wire cutters if you’re concerned, but it should not be necessary.Ĭonnect your RD-Wireless device to your home WiFi network The right side of the board will rest on the Active/Bypass sensor switch and be a little higher.Make sure the sides of the RD-Wireless are lined up with the sides of the back terminal board.Install the RD-Wireless where the ribbon cable was previously.Unplug the old timer’s flat gray ribbon cable from the back terminal board.